lil SOLID 2.0 Support introduced by IQOS - Getting Started

Language English

IQOS ILUMA PRIME

IQOS ILUMA

IQOS ILUMA ONE

lil SOLID Ez

IQOS ORIGINALS DUO

IQOS 3 DUO

IQOS 2.4 PLUS

lil SOLID 2.0

Using lil SOLID 2.0

First slide the cover open and insert a tobacco stick for heating designed for lil SOLID with the tobacco side into the device. Press for 2 seconds and feel a vibration signaling that the device is ON. The device will pre-heat for up to 25 seconds. When the pre-heating process comes to an end, the light comes on, it vibrates again and is ready to be used. The device vibrates and blinks to signal the last 3 puffs or 30 seconds, whichever comes first. Twist the tobacco stick more than 3 times in the same direction, remove the heat stick and close the cover.

That's it. Your device is ready for another use.

Charging your lil SOLID 2.0

Charging your lil SOLID 2.0 is simple.

Keeping track of the battery is easy. While charging, the status LED blinks. When charged, the light goes off. If the light is blue, your battery level is between 100-60%. If it's ice blue, your battery level is between 60-30%. And if it's orange, your battery level is between 30-1%, you should charge. If the device light is red then you are out of battery and you need to charge.

Cleaning your lil SOLID 2.0

Cleaning your lil SOLID 2.0 is simple.

Always turn off your device before you do it.

Open the cleaning wiper from the dual cleaner
Pull off the cap from the device
Use the cleaning wiper to clean the heating pin
Open the cleaning brush from the dual heater
Use the cleaning brush to clean the inside

For an optimal experience, clean after every 20 uses.

You can also clean with heat. Quickly press the start button 5 times. The LED light will blink orange for 90 seconds. When the cleaning is done, the light goes off and you will feel it vibrate twice.